~Toughbooktalk~

$20 a sheet plus shipping. Sheet is as shown in photo.

One sheet will do one CF 31.
$20 will get exactly what is pictured.
Actual metal doors are NOT included. That is just an example showing the application.

Media door
Battery door
Rear door
Hard drive door
Bottom housing section without text.

Private message for more information.

I have a set of these. Exactly as pictured and very nice.

Thanks Shawn,

Jeff...........

Thanks for the testimonial Jeff

I made memory door stickers also

Very nice Shawn! If my OEM stickers were not in such good shape, I would be a customer!

Thanks Bill.

What's your "take" on Bondo Glazing and Spot Putty? https://www.walmart.com/ip/Bondo-Glazin ... z/16927984

I did some reading where several pros said don't use anything that doesn't use a hardener.

Since the dents would be covered with a sticker I'm tending to ignore this good advise. One "Modeler" really liked the product

I'm talking about filling dings and dents in the memory door before adding the label.

Thanks,

J

single part stuff
2 part stuff

buy them here..

http://www.tptools.com/Nitro-Stan-Red-G ... ,1809.html

http://www.tptools.com/USC-Icing-Finish ... ?b=s*icing

Jeff,
I think I am going to try that spot putty you linked to.
It should be plenty good enough for what we are doing.