Page 1 of 1
What comes after mup in XP safe mode.
Posted: Sat Dec 29, 2012 10:39 pm
by SHEEPMAN!
New install CF-30MK3. Vista downgrade to XPP.
Gets to a point and re-starts. Safe mode w/command line the last entry is mup.exe? bluetooth?
The very next thing it checks re-sets the computer to boot. Goes by too fast to read it.
Anyone?
I've done default sequence. I'll check ram tomorrow.
It's supposed to have a short (intermittent bad connection) in touch screen. Maybe that?
Thanks,
Jeff
Re: What comes after mup in XP safe mode.
Posted: Sun Dec 30, 2012 12:14 am
by Springfield
I've seen a MUP error being a Windows XP configuration issue. Might be related to the hardware abstraction layer -- Mnem would know this better. Was this a load from factory CD, OEM, another image, or ...?
Re: What comes after mup in XP safe mode.
Posted: Sun Dec 30, 2012 3:00 am
by SHEEPMAN!
Factory. I don't think it's the mup, I think it's the next item.
I'm gonna run a Linux disk through tomorrow and see if anything pops up.
Re: What comes after mup in XP safe mode.
Posted: Sun Dec 30, 2012 6:14 am
by ADOR
I had a odd error on a laptop at one time. I think it was wireless related. I went into bios and disabled bluetooth, wireless and other stuff like that then it loaded up right.
Re: What comes after mup in XP safe mode.
Posted: Sun Dec 30, 2012 2:10 pm
by SHEEPMAN!
Good call. This has a 5100agn. I thought maybe the hdd but that's o.k. Lappy likes and runs 10.10 Ubuntu with a touchscreen fault. I'll fix that and then try the restore disk again.
Thanks
Re: What comes after mup in XP safe mode.
Posted: Mon Dec 31, 2012 9:17 pm
by SHEEPMAN!
Fixed TS, added calwin.exe for calibration. Set up to run Vista. I'm good now but would like a work around for the model not supported bit.