~Toughbooktalk~

I have a customer that broke one and I need to replace it for him.

Please provide ASAP.

Thanks

For which model exactly is it? I may have some of these cables but need to know what exactly it's for.

These are for CF-30's. Picture attached - Cable circled in red.

I will take more than 1 if you have extras. 5 is good

Please let me know.

Thanks

Rob,

Sorry for the delayed response. I will definitely let you know by tomorrow night.

Please. Thanks

Rob,

Some bad news. I do not have any of those ribbons.

Nice...

I still need these!

HELP!

Rob! Is the ribbon cable you need has an opposite end(face up and down at both end) where you slide in on to the connector or is it at the same side.

Maybe I can help. Let me know the orientation of the cable coz based on your picture I only see one end of the cable ribbon and the other end is not visible.

teo

Teo, it is opposite One end is open on one side and the other end is the opposite side of the cable.

Thansk!

Perfect! Ok! Here is the solution to your problem, Remember the CF-29 that you whipped on the wall! There are a lot of cable ribbon in there that you can harvest for future use. They all have 0.05mm pitch which is perfect to all your need. Anyaway, If you have carcasses from other unit like on CF-18. The audio board cable ribbon can be use or even on CF-29 that connect the keyboard pcb connector to mbo. I know its to wide, I think it 50C or 40C i've guess. What you need is count 1-12 depending on how many conductor and then pull out carefully the no.13 conductor as your guide when you cut it out. Cut precisely for 12 pin ribbon cable and viola! your problem solve. Thats what I always done when i've got no exact cable ribbon available.

Good Luck!

teo